Comments
-
This could be a problem in CFS (Content Filter). We recently had similiar issues with some microsoft websites and did create exclusions for specific devices in the internal network. Could you try to disable the CFS policy temporary which includes the zone to see if this is in CFS?
-
@Ajishlal ,thank you for sharing this with me. Do you have any VLAN's configured on the WAN switch? Don't know if the sysadmin of that company have done that, but maybe useful to know. Thanks! Joury
-
Hi @Ajishlal , Thank you for the information provided. Do you also have a switch between ISP modem and SonicWALL's? Just try to figure out if there's a problem in the setup. But it's good to hear that it works for others in Gen 6 with a fail over time of 1-2 min. I am a little bit confused that stateful works in your…
-
@MasterRoshi , no I didn't. Wasn't aware of this tool. But will be very helpful for the SonicWALLs in the future that we want to migrate from G6 to G7. Thank you for this helpful tip.
-
@BWC , you are right, they were imported from Gen 6 (NSA2600 Appliance). The problems that you have seen at network routes in the early days of Gen 7, were they also imported of a Gen 6 appliance? Thanks! Joury
-
Hi @BWC Thank you for your reply. We are running the same firmware version (7.0.1 R5023) as you. When following your steps I am able to create, clone and change the service port of the cloned rule. In that case the two rules are not grouped to each other when I select one of these. When I try to change/edit an existing NAT…